I am a brand new developer in every sense of the word. When I tried to submit my app to ITunes I received this issue that had to be resolved. It tested fine with an Iphone 4. When I did test it with an Iphone 3G I realized why it is so important. Any help would be GREATLY appreciated!!

Check out this link for complete instructions: http://stackoverflow.com/questions/4198676/warning-iphone-apps-should-include-an-armv6-architecture-even-with-build-config Mark

Thank you Kindly Mark!! I truly appreciate it!

Thank you Kindly Mark!! I truly appreciate it!

Thank you Kindly Mark!! I truly appreciate it!

@Mobile Freedom, Hi, have you been able to resolve your issue? I have the same error message showing up but can't make sense of the solution. Thanks, Farcat

Hi @farcat, did you add Required Device Capabilities to your .plist? or are u stuck on how to add it to your .plist?

Hi Farcat....As soon as I figured it out I had to update everything to 5.1 and now my issue is this: "No Identities are available for signing" This happens when I go to the Organizer Archives to Validate my app. Can anyone assist with this?

The build of the app is a success and Im trying to Validate and send to Apple for approval.

Hi @ianjamespiano, Thanks for the offer to help. Yes i was stuck on how to add the Required Device Capabilities to my .plist. Very afraid to mess things up you see. However, turns out I didn't need to, this morning I just changed my Targets Build Settings "Build Active Architecture Only" to NO and I was able to submit. In Project it is still set up as "Yes". @Mobile Freedom, have you managed to change you architectures to armv6 and armv7 as per GoNorthWest suggestion? Farcat

Ok great, I changed my architectures to armv6 and armv7 to allow installation on older iPhones :)

Yes I did Farcat. Thank you. Do you have any suggestions for my current issue?

I am a newbie myself so I am probably not the best person to advise you but I'll try to help anyway. Have a look at my last post on this thread about changing the "Build Active Architecture Only" to NO and see if it works. It did for me. If it doesn't go back to the link that Mark gave you, read on and you will see an entry about adding Required Device Capabilities to your .plist. I haven't tried it myself but maybe that's what you need to do. Good luck Farcat

Yes I did Farcat. Thank you. Do you have any suggestions for my current issue?

Thank you.... Ill try it as soon as possible!! : )

Thank you.... Ill try it as soon as possible!! : )

@Mobile Freedom, all your entries come double. I have noticed that it sometimes happens when you have more than one buzztouch.com window open at the same time. Farcat

Sorry about that. Just one page open. I realize it happens when I refresh the page to see the update. Wont happen again. With my issue...it was set to "No". Tried "Yes" and the same issue. WHats happening is that Xcode is sacking me to chose an application record and an identity to sign with. I realize you're a novice like I am but maybe you had this issue. It happened when I upgraded Xcode to run the 5.1 update.

Sorry, I am running dry. Maybe somebody else more knowledgeable than me could chip in? Farcat

Sorry about that. Just one page open. I realize it happens when I refresh the page to see the update. Wont happen again. With my issue...it was set to "No". Tried "Yes" and the same issue. WHats happening is that Xcode is sacking me to chose an application record and an identity to sign with. I realize you're a novice like I am but maybe you had this issue. It happened when I upgraded Xcode to run the 5.1 update.

No Problem! Thanks for the attention!! ....There I go again....It actually refreshes by itself when I open the page up.. Ill log out.. lol